Maintenance and Repair of Air Compressors

How to Conduct Proper Maintenance and Repair of Air Compressors

Carrying out repair and maintenance to air compressors can be a complicated task. However, if performed well, it makes your compressor work impeccably, guaranteeing your long term usage.

Follow The Procedure On How To Repair Air Compressors below!

Intake System

Verify the state of the filters and valves and check your notebook when it was the last time you made a change. Make sure it is not broken or deteriorated. If it deteriorates, clean very well and reassemble, remember to note the day you make the change.

If the filters are no longer in good condition, you must change them at once. Remember that they do a fundamental part of the work. The same applies to the valve. If it has expired or suffered any damage, change it completely.

Lubrication System

If your compressor is one that uses oil or another type of lubricant for its operation, you must be aware of doing the corresponding maintenance

Measure the oil level, its color, and texture at least once a week. This will allow you to know if there has been any damage. Also, carry out the lubricant changes according to the manufacturer’s instructions.

If you detect that your compressor is losing oil or that its color darkens very quickly or loses viscosity, then you must change the seals and filters, as this can cause severe damage to the machine.

Condensing System

Check the current state of the condenser and measure the level of water present in it. Clean everything and lubricate the parts that need lubrication and reassemble.

If you notice that the water level is higher than indicated and water leakage towards other components, change the seals and check the drains and change all the parts that you must change.

Gear and Belt System

Check that the gear does not present any broken or bent teeth. Clean very well and lubricate the parts that require it and reassemble. With the belts, check the tension they present and if their tension is stated by the manufacturer, clean well, and reassemble. Be careful not to disassemble if you do not know how to reassemble, to avoid further damage.

If the gear has rolled teeth, twists, or stops during operation, replace it with a new one. In the belts, if it has lost the tension recommended by the manufacturer, you must make the corresponding change, since this can spoil the operation.

Electric System

Check that all electrical components are working in the best way, that there is no type of burn, sulfation, or corrosion, and that all cables are covered and without cuts. If so, remove dust and dirt off it and reassemble.

If any of the electrical components is faulty, broken, or sulfated, you must change it, as this can cause damage and malfunction of the machine.

Ejection System

Please verify that the filter, exhaust valves, and drain hoses are in good condition and that it does not present any breakage, it cleans very well and removes accumulated dirt and dust.

If any of the components of the expulsion system are broken or deteriorated, change it immediately since they can damage the complete compression mechanism.

I hope that this article on air compressor maintenance has been useful to you and you can put the advice into practice to give your compressor a long life.

Leave a comment

Your email address will not be published. Required fields are marked *